Setting Fiberhome hg6145d2 Bridge

Setting Up FiberHome HG6145D2 as a Bridge with IndiHome Firmware

The FiberHome HG6145D2 modem with IndiHome firmware does not have a manual bridge mode setting. However, it can still be used as a bridge by default. When tested, DHCP did not work through the Ethernet port, but WiFi functioned normally.

Default Credentials

• Location: On the back of the modem

Setup Steps

1. Reset the Modem

   • With the modem powered on, press the reset button for several seconds until the lights go off.

2. Connect to the Modem

   • If using a LAN port, set your PC's static address to 192.168.1.2.

3. Access the Modem Interface

   • Open a web browser and go to http://192.168.1.1.
   • Username: admin
   • Password: %0|F?H@f!berhO3e

4. Configure Network LAN

   • Set the LAN network to match your main router's subnet.
   • Save the settings.

5. Disable DHCP

   • Turn off DHCP and save the settings.

6. Restart the Modem

   • Restart the modem.

7. Connect to Main Router

   • Connect a LAN port from the main router to any port on the modem.

8. Test the Setup

   • Test to ensure all ports and WLAN are bridged properly.

This should complete the bridge mode setup for the FiberHome HG6145D2 modem.